当前位置:首页-新闻资讯

合金铝板生产厂家的存放要注意?

来源:http://www.jndclyyxgs.com/ 发布时间:2018-01-17

一、针对该铝板的运输,一定要严禁推拉、抽取等行为,这样容易造成版面的损伤或是刮伤。尽量将合金铝板的四边同时抬起放下,这样可以使得板材不容易遭受损伤。
1. For the transport of the aluminum plate, it must be strictly forbidden to push, pull, draw and so on, which can easily cause the damage or scratch of the layout. Try to lift the four sides of the aluminum alloy plate at the same time, so that the plate can not be easily damaged.
二、铝板在置放期间,一定注意不要和任何化学物品、潮湿性的材料放在一起,这样容易造成腐蚀的现象产生。
Two. During the placement of the aluminum plate, we must pay attention to not being put together with any chemical or damp material, which can cause corrosion easily.
三、合金铝板在运输过程当中,应该选用符合标准的布料将其盖好,这样可以避免雨水或是雪霜的侵入,导致产品表面受到不同程度的损伤。
Three, during the transportation process, the aluminum alloy plate should be covered with standard cloth, so that it can avoid the invasion of rain or snow and frost, and cause the surface damage of products to varying degrees.

铝板生产厂家
四、对于合金铝板厂家的长期置放环境,一定要保持干燥通风、有着明亮无腐蚀的环境条件,这样才能保持铝板的性能以及质量。
Four, for the long-term placement of aluminum alloy plate manufacturers, we must keep dry, ventilated, bright and non corrosive environmental conditions, so as to maintain the performance and quality of aluminum plates.
五、针对合金铝板的置放空间,也需要定期进行清洁打扫,不能让多余的灰尘、杂物长期附着在铝板表面。
Five. For the placement of aluminum alloy plate, it is necessary to clean and clean regularly, so that the excess dust and sundries can not be attached to the surface of the aluminum plate for a long time.
六、铝板厂家在这里提出来一个建议,在置放的时候较好点一些隔离材料,将合金铝板与地面隔离开来。通常保持在十厘米左右的距离,这样更能使得铝板不受到地面的潮湿影响,从而维持质量和性能。
Six, the aluminum plate manufacturer put up a suggestion here that it is best to point out some isolating material when placing it and isolate the aluminum plate from the ground. It is usually kept at a distance of about ten centimeters, so that the aluminum plate will not be affected by the humidity of the ground, thus maintaining the quality and performance.