很多人在购买完铝卷之后，一定要记得放置好 ,因为放置的不到位，很容易让铝卷出现氧化的情况，这样就失去了我们购买铝卷的意义了。因此大家有必要了解一下铝卷应该放置在什么地方。
Many people must remember to place the aluminum coil well after purchasing it, because if it is not placed in place, it is easy to cause the aluminum coil to oxidize, thus losing the significance of our purchase of aluminum coil. Therefore, it is necessary to know where the aluminum roll should be placed.
1.将铝卷用塑料薄膜包妻好，如果条件允许的话，好是放置在有干燥剂的地方，这样能够将空气里面的水分吸收，从而避免了出现氧化的问题；
1. Wrap the aluminum roll with plastic film. If conditions permit, it is better to place it in the place with desiccant, so as to absorb the moisture in the air and avoid the oxidation problem;
2.如果铝卷是放在木箱里面的，那么我们要保证木箱的湿度要小于18% ,而且铝卷的温度不能高于45°C ,大家不要记错了；
2. If the aluminum coil is placed in the wooden box, then we should ensure that the humidity of the wooden box is less than 18%, and the temperature of the aluminum coil should not be higher than 45 ° C. don't make mistakes;

3.如果在放置期间突然由低温区域转到高温区域，那么我们不要立即将包装打开，因为这样很容易出现氧化的情况，我们应该等到铝卷适用之后在进行拆封，这样就不会出现氧化的情况；
3. If it suddenly changes from the low temperature area to the high temperature area during the storage, we should not open the package immediately, because it is easy to oxidize. We should wait until the aluminum coil is applicable before unpacking, so that there will be no oxidation;
4.如果仓库里面漏雨、漏雪，那么不应该放置铝卷，这样很容易让其出现氧化的情况，这一点一定要切记。
4. If there is leakage of rain and snow in the warehouse, aluminum coil should not be placed, which is easy to cause oxidation. This must be remembered.
铝卷既可以整卷包装，也可以分成小卷；铝卷衬纸芯或铝芯，以防止铝卷变形，或受挤压发生弯折；铝卷要用塑料布密封，封口用透明胶带密封好，防止水汽进入造成铝卷腐蚀变色外包装使用厚纸壳包装紧实，也可在塑料布与纸壳之间加一层牛皮纸，将包装好的铝卷放置在木托上，并用钢带加固。
The aluminum coil can be packaged in whole or in small coils; the aluminum coil is lined with paper core or aluminum core to prevent the aluminum coil from deformation or bending due to extrusion; the aluminum coil shall be sealed with plastic cloth, and the sealing shall be sealed with transparent tape to prevent water vapor from entering into the aluminum coil to cause corrosion and discoloration of the aluminum coil. The outer packaging shall be tightly packed with thick paper shell, and a layer of kraft paper can be added between the plastic cloth and the paper shell to make the packaged aluminum The rolls were placed on wooden brackets and reinforced with steel strips.