来源：http://www.jndclyyxgs.com 发布时间：2018-07-07 16:28:22
Aluminum sheet is processed by aluminum roll in pressure type equipment (color steel tile equipment). It is similar to edge rolling and folding processing technology. Aluminum plate is processed into various types of pressure aluminum plate. It is mainly used in roofing, power plant desulfurization, anticorrosion and heat preservation and other industries.
The common specifications of aluminum sheet pressing processing: usually the aluminum plate is the most commonly used type YX35-125-750 type, especially in the power plant anticorrosion and insulation engineering, flue gas desulfurization and anticorrosion engineering is the most commonly used, the thickness is more than 0.5-1.2mm thickness, material is often 1060, 3003, 3A21, LF21 and other materials. Shanghai Lun Meng aluminum products Co., Ltd. provides high-quality aluminum sheet, corrugated aluminum plate, aluminum tile and other products all the year round. Welcome to inquire.
Second kinds of common aluminum plate compression processing model for YX23-210-840 model, often have roof and wall aspects, we call the type 840 type of pressure aluminum plate, sometimes many factories and workshop roofs with color coated aluminum rolls for pressure type often select the 840 type of pressure aluminum plate.
In the process of pressing, the length and thickness of the aluminum plate should be paid attention to in the process of pressing the aluminum plate, so as to avoid the burr caused by wear because of the equipment problem. When the aluminum sheet is pressed, the packing is also suitable for waterproofing and moisture proofing. At the same time, it is recommended not to choose the products with too high hardness in the material of aluminum plate. The aluminum rolls of H24 or H16 can be selected as raw materials for aluminum sheet pressing. If the hardness of the aluminum plate is too high, it will cause the fracture problem during the process.
The common problem in press machining: the main problem in the compression machining is that the flatness of the aluminum coil is not good and easy to run off, so it is suggested to use the tension bending correction and the leveling to avoid the deviation in the process of the aluminum plate pressing. Shanghai Lumeng Aluminum Co., Ltd. provides all kinds of high quality aluminum plate for all kinds of equipment. It is suitable for all kinds of equipment, such as electric power, roofing, equipment tank and so on. The spot supply is 0.5 millimeter, 0.6 millimeter, 0.7 millimeter, 0.8 millimeter, 1 millimeter and other thickness of pressure type aluminum plate and insulating aluminum skin, color coating fluorocarbon and polyester press aluminum plate and so on Products.